5
OPERATION AND MAINTENANCE
POWERLIGHT RESCUE Operating and Safety Features
The POWERLIGHT RESCUE is an ideal power supply for powering and/or recharging
small electronics connected through its USB power ports. With 12000 mAh of power, it
can recharge multiple devices on a single charge.
The POWERLIGHT RESCUE can serve as a vehicle jump starter when the included
output cables and clamps are connected through the 12V cable port. It is designed to
jump start vehicles of all shapes and sizes up to a V8 gasoline engine.
The POWERLIGHT RESCUE features a variety of safety features, including reverse
polarity protection, backfeed protection, short circuit protection, over voltage protection
and under voltage protection to make jump starting safe and hassle free.
The POWERLIGHT RESCUE also features multifunctional work light capabilities. It can
be deployed as a 480 lumen work light, a 3W focus beam light, a 3W SOS emergency
light, a red warning light or a red blinking warning light.
CHARGE STATUS AND RECHARGING PROCEDURES
Note: Upon initial purchase, your POWERLIGHT RESCUE should be charged for a
minimum of 6 hours.
Charge Status Indication
Press the Power Button on the front of the unit one time to see the unit’s state of
charge. The unit’s state of charge status is indicated by four LED indicators below the
Power Button, as follows:
One Blue Status LED = Recharge Immediately
Two Blue Status LEDs = 25-50% Charge – Charge soon
Three Blue Status LEDs = 50-75% Charge – Charge if using as a jump starter
Four Blue Status LEDs = At or near full charge
It is recommended that the unit be at or near 100% state of charge when using as a
jump starter. This will greatly improve your odds of success.
