INSTALLATION AND USERS GUIDE
Preparation and Notes
•
Before using the product, remove the foam (protecting the UV tube) inside the product: pull
up the 2 locking Tabs to open the Grid and take the foam out carefully, then re-install the
Grid.
•
The 3 universal wheels of this device had been turned
inwards and fixed by 3 screws at the center of the bottom
when it was packed. Before moving and using the product,
the 3 wheels must be installed back to the correct positions:
pressing the 3 screws and swing the wheels outwards 180
°
,
then fix the wheels in place using those 3 screws.
•
Keep in mind of the following information:
Delayed Start Time
Recommended Disinfection Times/Areas
3 minutes
30mins/60m²
60mins/120m² 120mins/180m²
•
Place the supplied Warning Sign in a conspicuous place at the entrance/exit of disinfection
area.
•
Make sure the path to exit the disinfection area is clear before starting the device.
•
The operator must wear anti-ultraviolet protective clothing and the UV Glasses before
operating.
•
The operator must leave the disinfection area and close all entrances after starting the
device, make sure the entrances are locked or safeguarded during the entire disinfection
process.
•
For safety reasons, when the UV lamp is operating, it will turn off when the sensor detects
movement and it will immediately continuous audible dual beep and flashing red and green
LED indicator lights will engage. The lamp won’t restart again. The operator will have to
manually or remotely re-start the light again to ensure the area is disinfected.
•
To avoid moving by itself, this device must be placed on an even surface and always apply
the wheel brake before operating.
