Light Bright
Arond 200
The maximum ambient temperature of 45°C must not be exceeded.
Do not operate the device until you have familiarized yourself with its functions. Prevent
operation by persons who are not qualified to use the device. Most damage is the result of
improper operation!
Please use the original packaging or specially adapted flight cases when transporting the
device.
3. Unpacking the device
Contents of the package: The headlight, a PowerCon connection cable and Omega brackets
for mounting.
Open the packaging carefully on the top side and check the headlight and accessories for
possible transport damages. These should be reported immediately to the transport
company.
4. Installation
The device comes with a ready made-up Powercon connection cable. Please use only the
supplied cable or a cable of the same type assembled by a specialist. The connection of the
device to the power supply must also be carried out by an authorized specialist.
Connection in Germany/Europe:
Connected loads: voltage 100-240 V, frequency 50 - 60 Hz, power max. 260W, 1.2A
The electrical safety as well as the function of the device is only guaranteed if it is connected
to a properly installed protective conductor system. It is very important that this basic safety
requirement is present. In case of doubt, have the electrical installation checked by a
specialist. The manufacturer cannot be held responsible for damage caused by a missing or
interrupted protective conductor (e.g. electric shock)! Only use the device in a completely
assembled state so that no electrical components can be touched. (
danger 100-240 V
)
If you have observed the listed points, you can plug in the devices or have them connected to
the mains by a specialist.
Leiterfarbe
Funktion
Symbol
Brown
Phase
„L“
Blue
Neutral conductor
„N"
Yellow/Green
Protective earth
„PE“
⏚
6
