INSTALLATION GUIDE
FFLA generation 2 Series LED Flood
Instructions and specifi cations are subject to change at any time without notice. Copyright© 2021 PacLights All Rights Reserved
Page 1 of 4
Need help? (800) 988 -6386 Email: [email protected] Website: www.PacLights.com
PL_INST_FFLA/2_v0
FFLA/2 3CCT (Color Coordinated Temperature) & LUMEN FIELD SELECTABLE WITH PHOTO CONTROL
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
PacLights fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required for safety.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR
WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNINGS:
•
Make certain power is OFF before installing or maintaining fi xture. No user serviceable parts inside.
•
To prevent wiring damage or abrasion, do not expose wiring to edges of sharp objects.
CAUTION:
•
For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened fi rmly. Apply weatherproof silicone
sealant around the edge of the Back Box and/or Junction Box. This is especially important with an uneven wall surface. Silicone all plugs and
unused conduit entries.
FIG. 1
FFLA/2
15/30
FFLA/2
50
FFLA/2
70/90
The Selectable CCT & Lumen output is equipped on selected models.
If the CCT or Lumen output needs to be adjusted or if the Photo
Control turned on/off , remove the clear plastic Cap Screw from
the back of the FFLA/
2
fi xture (Fig. 1). The Dip Switches can be
accessed easliy inside the fi xture (Fig. 1a).
Connect the ACL and the ACN from the FFLA/2 Fixture to the conduit with the AC power Supply Cable. Follow the Wiring Diagram provided.
AC POWER SUPPLY
FFLA/2 DRIVER
GRA
Y (-)
PURPLE (+)
HOT [BLACK]
NEUTRAL [WHITE]
GROUND [GREEN]
WIRING DIAGRAM
DIM
INPUT
There is a Dip Switch Chart to follow next to the Dip Switches inside.
The fi rst set of Switches controls the Lumen output. The second set
controls the Photo Control ON/OFF and the Color Temperature
(Fig. 2). After the selection is made replace the clear plastic Cap
Screw and carefully tighten.
BACK
COVER
FFLA/2 FIXTURE
CAP SCREW
FIG. 1a
1
2
DIP SWITCHES
DIP SWITCHES
80%
100%
70%
90%
PH ON
PH OFF
3000K
4000K
5000K
FIG. 2
