Light & Motion Stingray HD, Owner'S Manual

Page: 17 / 20

Mounting Battery Pods
1. Remove the monitor back on the housing.
2. Slide the battery pods into housing channels.
3. Insert Pod Locker between the pods and tighten using 1/8” Allen key.
Do not over-tighten.
Connecting Lights to Battery Pods
(Sunray 1000/2000)
1. Plug in the cable connectors on the pod by orienting the small silver guide
pin with the small hole in the bulkhead.
2. Tighten the locking sleeves by rotating clockwise until tight.
16
Installing Batteries
1. Slide the battery back into the pod with the contact end inserted first so
that the connector will align with the socket inside the pod (Refer Fig. 15
on previous page).
2. Inspect the O-ring on the pod cap. (See O-ring maintenance, pg. 13).
3. Replace the front cap onto the pod.
Insure that the removal strap attached to the battery does not
interfere with the seal when the end cap is attached to the pod.
4. Turn the knob on the end cap clockwise 1/8 turn until it stops. The end
cap is now locked into place. The end caps are specific to the left and
right pods.
@