Light & Motion Stingray HD, Owner'S Manual

Page: 12 / 20

11
Moisture Alarm
(refer Fig. 13)
LCD Moisture Alarm - Audio and visual alarms will signal if moisture is
detected inside the housing. Alarm performs a three second diagnostic check
when initially receiving power.
When camcorder transitions from Memory to Camera modes there is
a 2-3 seconds pause while the camcorder keys the tape. The Monitor
Back will black out during this time and LED alarm will sound when
Monitor Back is re-powered.
Pre-Dive Checklist
1. Install the appropriate media into the camcorder.
2. Install a completely charged battery in the camcorder.
3. Verify operation of all housing controls.
4. Check that the front bayonet port is securely engaged and that the latch
pin is in the locked position. Clean lens if necessary.
5. Check that the monitor back O-rings are seated correctly and that the
rear latches are in the closed and locked position.
First Time Use
All Light and Motion housings are pressure tested prior to shipping.
However, there could be unseen damage due to shipping. A test
dive without the camcorder in the housing is recommended.
After the initial dive with just the housing, make the following checks:
1. Dry off housing exterior.
2. Remove the monitor back and visually inspect for moisture.
3. Reach inside the housing and trace a finger around all view ports and
mating surfaces.
4. If any water is detected, contact the housing reseller or the Light &
Motion service department.
After Diving Care
1. Immediately submerge the housing in fresh water. While in fresh water,
work all the switches and press all the buttons, to work any remaining salt
water out of the housing buttons.
2. Remove housing from rinse tank and then simply towel dry.
@
@