Light & Motion Stingray HD, Owner'S Manual

Page: 7 / 20

(Fig. 3) (Fig. 4)
(Fig. 6)
Camera Tray Release
Mounting the Camera
1. Remove the monitor back by pushing the latch locks in and rotating the
latches down and forward of the housing body (Refer Fig. 3).
2. Remove the camera tray. Push the camera tray forward with one
hand. With your other hand press the tray release latch down (Refer Fig
4). Gradually release pressure with the hand holding the camera tray and
the camera tray will slide out of the housing.
3. Configure the camera tray. Refer to the separate configuration sheet to
determine if you need to change the adapter tray orientation or the size
spacers for your camcorder.
4. Position the camera tray underneath the camera’s tripod mount and
tighten.
5. Connect the cable on the front of the camera tray to the camcorder’s
microphone jack. Note, the 2.5mm microphone jack is not included on
some camcorders.
6. Attach the large yellow cable to the camcorder’s A/V Out (or A/V R). It
may be necessary to partially insert the camera and tray inside the housing
depending on the location of the A/V Out jack on the camcorder (Fig. 5).
7. Slide the camera tray forward until the latch engages.
8. Install 4 high capacity rechargeable AA batteries into the monitor back
(2400 mAh or higher Nickle Metal Hydride) .
9. Plug the video out cable from housing into monitor back (Refer Fig 6).
(Fig. 5)
6
A/V Out Connector