LIFT eFOIL 4'4 Pro, Instruction Manual, Page: 35 / 48

3. Power on the hand controller by pressing the power button above
the screen. The Lift logo will appear, followed by a battery icon, which
will appear on the hand controller’s screen. This confirms that the hand
controller and board are properly paired.
NOTE: The Lift eFoil must be turned on to confirm the connection and
activate functions of the hand controller.
NOTE: If the hand controller screen indicates “no signal,” the board
and hand controller are disconnected. Please review the PAIRING THE
CONTROLLER section on p. 22.
4. Once pairing has been confirmed, make sure the propeller is free
and clear, and give the controller a small amount of throttle to spin
the propeller.
NOTE : The propeller should be rotating clockwise when facing the front
of the board. If it is not, check the phase connector plugs to make sure
the colors match.
5. Once the propeller is confirmed to be spinning counter-clockwise,
press the power button on the hand controller to turn it off.
CAUTION: DO NOT transport the board with the hand controller
turned on. Always turn off the hand controller in any instance when
you’re NOT riding the eFoil.
CAUTION: DO NOT run the motor out of the water except for a brief
check that it is working correctly.
6. Finally, inspect the board compartment seals to ensure that it is free
from damage and debris. Carefully close the lid and fasten the latches.
7. Ensure the board compartment is sealed.
35