BPM 1000i
Blood Pressure Monitor
Battery Installation
Place the batteries in the monitor in the following order:
9
1
2
3
4
1.
2.
3.
4.
After battery installation, it is required to set
the year, date and time first. A correct date
and time is very important for tracking your
blood pressure recordings. Related setting
procedures are provided in the “Setting the
Time” section on page 14.
Connecting Cuff to the Unit
Insert the cuff jack into the cuff inlet on the left side
of the unit.
Fitting the Cuff
1. Wrap the cuff around a bare-skinned left
upper arm. Be sure the air tube points down in
the direction of lower arm when it comes out
of the cuff.
2. Tighten the cuff, but make sure it is not too
tight so that you allow proper inflation.
The cuff's lower edge should be about one
inch from the elbow.
3. If it is not possible to fit the cuff to the left arm,
it can also be wrapped around the right
upper arm.
The standard cuff equipped with this device is a Medium size. It is
suitable for those with an arm circumference between 22cm to 32cm
(8.75 ~ 12.5 inches). Arm sizes out of this range might cause an incorrect
measurement
.