lifeSMART LS100DX, Owner'S Manual

Page: 16 / 28

13
CONTROL PANEL OPERATION
ADJUSTiNg PRESET FiLTER cYcLES
Filter duration is programmable between 0 and 6 hours in 30 minute increments (0.5 hours) for
both filter cycles. To program the cycle times:
1. Press and hold light button for 5 seconds until F1 is displayed.
2. Press the Plus or Minus button to adjust the cycle time for F1.
3. Press the light button to store the F1 cycle and move to the F2 cycle.
4. Press the Plus or Minus button to adjust the cycle time for F2.
5. Wait 15 seconds to allow the exit timer to expire and store the setting.
IMPORTANT:
To reset the first filter cycle start time, skip step 5 and continue pressing the light
button until the actual temperature is displayed. Powering down of the spa will also reset the first
filter start time.
FiLTER cYcLE SUSPENSiON:
The filter cycle will be suspended every time a jet pump or
light is activated manually during the filter cycle time. The suspension will end 10 minutes after the
completion of the manual use.
OPERATiONAL MODES
The Standard Mode is the default operational mode preset from the factory.
STANDARD MODE:
Is programmed to maintain the desired temperature.
EcONOMY MODE (LS600DX MODEL ONLY):
The spa will heat normally during the filter
cycle; outside of the filter cycle, the set point will be lowered by 20°F. To enter the programming
screen and toggle between Standard and Economy Mode the following is required:
1. Press and hold the light button for 5 seconds
2. Press the
light
button several times until EP 0 or EP 1 is displayed.
3. Use the Plus or Minus button to choose between Standard and Economy Mode.
EP 0 = Standard Mode and EP 1 = Economy Mode.
4. Wait 15 seconds to allow the exit timer to expire and store the setting.
OFF MODE:
This mode allows you to stop all spa functions for 30 minutes to perform quick
spa maintenance To place the spa in OFF MODE, press and hold the jets button for 5 seconds.
The display will toggle between OFF and water temperature when in the OFF MODE. To stop the
OFF MODE before the 30 minute cycle time is complete, simply tap (short press) the jet button.
FAhRENhEiT/cELSiUS SETTiNg
To Change water temperature display to either Fahrenheit or Celsius, press and hold light
button for 5 seconds until F1... is displayed. Press the light button several times until F or C
is displayed. Press the Plus or Minus button to change. Wait 15 seconds to allow the exit timer to
expire and store the setting.
SMART WiNTER MODE
The Smart Winter Mode is used to prevent water from freezing in the plumbing of the spa. As soon
as there is a risk of freezing, this protection kicks in. The SWM protection will turn back off only
after 24 hours without a risk of freezing. During this 24 hour period, the Smart Winter Mode icon
remains on; the icon blinks when the purge is active.