lifeSMART LS100DX, Owner'S Manual

Page: 15 / 28

12
Initial start-up - When the spa is first powered up the control system begins a 2 minute Startup
Mode. Different codes will display on the screen. Once Startup Mode completes, the actual tem-
perature is displayed on the screen,
and the spa will then begin to heat
and maintain the water temperature
and the first filter cycle will start. Your
spa has been designed so that it
will automatically heat the water to
the factory set temperature of 100 ° F
unless you set the spa to a different
temperature. If power is disconnected
from the spa, it will automatically
revert back to the last saved set tem-
perature when power is reapplied.
TEMPERATURE ADJUSTMENT (80°F-104°F/26°c-40°c)
The temperature can only function between 80°F - 104°F / 26°C - 40°C. The last measured
temperature will constantly display on LCD.
Press the
Plus
or
Minus
buttons to display the set temperature and indicator . Each time either
button is pressed again, the set temperature will increase or decrease depending on which button
is pressed. After five seconds, the LCD will automatically display the current spa temperature.
The heat indicator lights up when heating. It flashes when there is a request for more heat. Once
set temperature is reached the indicator shuts off and the low speed of the jet pump turns off after
30 seconds (if not in filter cycle).
JETS OPERATiON
For LS600DX model, firmly press the Jets button once to activate the low speed of the pump and
again for the high speed. Firmly press the Jets button again to turn off the pump. If left running the
low or high speed pump will automatically turn off after 1 hour. The "jets" indicator light next to the
button will blink when jet pump is on low speed and is solid on high speed. For all other models,
press the
Jets
button once to turn on the pump and a second time to turn off the pump.
MULTi cOLOR LED LighT
Press the light button once to turn on the light, the light indicator next to the button is lit when the
light is on. Press the button again to turn the light off. Every time the light is quickly turned off and on
a new light mode will appear. The sequence is as follows: White, Slow Full color wheel, Amber, Blue,
Red, Green, Purple, Blue/Green color wheel, Red/Green color wheel and Fast Full color wheel. The
last light mode used will come back on when the light is turned off for more than 2 seconds.
NOTE:
If left on, the light will automatically turn off after 4 hours of operation.
FiLTER cYcLES
There are two filter cycles: the first cycle (F1) starts right after power up and the second cycle (F2)
will start 12 hours later. The default duration for the first filter cycle is 1 hour, and 30 minutes for
the second cycle. Filter cycles (on LS600DX model) only run at low speed. The “Filter” indicator
lights up when a filter cycle is on. The duration of each filter cycle can be modified.
CONTROL PANEL OPERATION
jets Light
Indicator Lights
Temp
Minus
Temp
Plus