LifeSize Multipoint 230, Installation Manual

Page: 25 / 32

Performing Initial LifeSize Multipoint 230 Configuration 19
Changing the Global User Name and Password
5
Enter the appropriate number or letter at the prompt for one of these
options:
$
1 - 100Mbps Half Duplex
$
2 - 100Mbps Full Duplex
$
3 - 1Gbps Full Duplex
$
4 - Auto Negotiation
$
Other - Quit
Note
We recommend that you select “4 - Auto Negotiation”.
6
Press Enter .
The network configuration Main menu appears.
7
Do one of the following:
$
Enter the letter for the set of parameters that you want to configure.
$
Enter Q to save your changes and allow the device to complete the
boot process.
C
HANGING THE
G
LOBAL
U
SER
N
AME AND
P
ASSWORD
You can change the global user name and password that the LifeSize Multipoint
uses. You use this user name and password to access the configuration web page
for the LifeSize Multipoint. The user name and password are required for these
tasks:
"
Starting a Telnet session to monitor the LifeSize Multipoint
"
Upgrading the LifeSize Multipoint software
"
Uploading Interactive Voice Response (IVR) messages to LifeSize
Multipoint configuration memory
The default global user name is admin . The default password is password .
#!
Procedure
1
Start a terminal emulator session as described in the Setting the IP
Address for Both Blades on page 16.
2
Enter P at the prompt.
3
Enter the name that you want to use as the global user name at the Enter
User name prompt, and press
Enter .