LifeSize Multipoint 230, Installation Manual

Page: 24 / 32

18 LifeSize Multipoint 230 Installation Guide
Setting Ethernet Speed and Duplex Parameters
11
Enter the IP address of the router associated with the segment in which
the unit will be installed at the Enter Default Router IP Address prompt
and press
Enter .
Caution
Do not use leading zeros in the IP address.
12
Enter the subnet mask without leading zeros at the Enter IP Mask for
default device prompt and then press
Enter .
If you are not using a subnet mask, press Enter .
13
Allow the unit to complete the reboot process. A new emulator session
begins.
14
Close the terminal emulator session.
S
ETTING
E
THERNET
S
PEED AND
D
UPLEX
P
ARAMETERS
Use the serial port to set the Ethernet speed and duplex parameters that you want
the LifeSize Multipoint to use.
#!
Procedure
1
Access the LifeSize Multipoint through the serial port and start the
terminal emulator session.
Note
If the LifeSize Multipoint is already running, you need to reboot or
restart the device.
2
When the message “Press any key to start configuration” appears on the
screen, press any key within 10 seconds.
The network configuration Main menu appears.
3
Enter A at the prompt to display the Advanced Configuration menu, and
press Enter .
The Advanced Configuration menu appears.
4
Enter 3 at the prompt to select “Change LAN port Settings”, and press
Enter .