LifeSafety Power FlexPower Generation 2, Installation Manual

Page: 3 / 22

FlexPower Generation 2 DC Power System Installation Manual
ii iii
Symbol Definitions
The following symbols are used throughout this manual:
h
This symbol is intended to alert the installer of shock
hazards within the enclosure . Service should only be
performed by qualified service personnel
i
This symbol is intended to alert the installer of important
information intended to help the installer avoid personal
injury or property damage
Warnings
i
All references to FPO, FPO75, FPO150, or FPO250 in
this manual refer to the Generation 2 FPO family .
h
Installation and service should be performed only by
qualified service personnel and should conform to all
local codes
h
To reduce the risk of electric shock or fire, do not
expose this equipment to rain or moisture
i
This equipment shall be installed in a manner which
prevents unintentional operation by employees,
cleaning personnel, or others working in the prem-
ises, by falling objects, customers, building vibration,
or similar causes
i
This equipment is not intended for use within the pa-
tient care areas of a Health Care Facility
h
Replace fuses only with the same type and rating as
indicated in the specifications section of this manual .
i
To prevent impaired operation, ensure that all wiring
is routed and secured to prevent accidental open or
short circuit conditions
i
The system and any batteries (if used) should be
tested at least once per year to ensure proper opera-
tion
i
Batteries (if used) should be maintained at an am-
bient temperature of between 32 and 120 degrees
Fahrenheit (0-49 Celsius) or premature loss of bat-
tery power could occur
i
For UL294 compliance, the battery set must be sized
to provide a minimum of 4 hours standby at full load
Regulatory Information
The equipment discussed within this manual has been test-
ed to the following standards:
• UL294, UL603, UL1076
• ULC S318, ULC S319
• CSA C22 .2 #107 .1, CSA C22 .2 #205
FCC Information
Note: This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to Part
15 of the FCC Rules . These limits are designed to provide
reasonable protection against harmful interference when
the equipment is operated in a commercial environment .
This equipment generates, uses, and can radiate radio fre-
quency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interfer-
ence to radio communications . Operation of this equipment
in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interfer-
ence at his own expense .
Conventions Used Within this Manual
Positional information (e .g . top, bottom, up, down, left,
right, etc .) is referenced with the board or enclosure in the
orientation shown in the illustrations in this manual .
Notes and Warnings