Please read the operating instructions before using the
Surger Plus
.
Keep this manual for reference.
CHARGING THE BATTERY
• Fully charge your Surger Plus, for 3–5 hours,
before using it for the first time.
• Always slide the Power switch to the OFF
before charging the Surger Plus.
• To charge: connect the included charging
cable to the Micro USB port on the end of
the Surger Plus. Plug the input end of the
charging cable into a 5V 2A or 5V 1A charging adapter, such as a cell
phone charger.
• The 5 Battery Indicator LEDs will flash in turn during charging. When the
battery is fully charged, all 5 LEDs will remain lit.
• When fully charged, the Surger Plus will enter a dormant state to
protect the battery from overcharging.
• The Surger Plus may be recharged at any time, regardless of battery
level.
• For best results, do not completely drain the battery before charging.
• The battery must be charged at least once every 6 months.
• During use, the 5 Battery Indicator LEDs indicate the battery level:
• 5 LEDs lit = 76–100%
• 2 LEDs lit = 1–25%
• 4 LEDs lit = 51–75%
• 1 LED lit = 0%
• 3 LEDs lit = 26–50%
• Average run-time is about 4 hours per charge at the highest speed level
and 16–18 hours per charge at the lowest speed level.
USING YOUR
SURGER PLUS
1. Slide the
Power switch
to the ON position to turn on the Surger Plus.
The Power Indicator LED will turn on.
2. Press the
Power/Control button
to turn on vibration to speed level 1.
The 1200 RPM LED will light up indicating that speed level 1 is
selected.
3. Use the
Power/Control button
to toggle through the 5 vibration speed
levels (1450–2200 RPM) and then the 3 automatic modes
(M1–M3).
a. Press the button a second time for speed level 2, a third time for
speed level 3, a fourth time for level 4, a fifth time for level 5,
a sixth time for automatic mode M1, a seventh time for M2, an
eighth time for M3.
b. The speed or auto mode selected will be indicated by the Speed
Indicator LEDs or the Auto Mode Indicator LEDs.
3. With your desired vibration speed or automatic mode selected, roll a
muscle group across the Surger Plus. Apply pressure as needed.
4. Press the
Power/Control button
a ninth time to turn off vibration.
5. Vibration will auto shutdown after 15 minutes of use. To continue
using, just press the
Power/Control button
to turn vibration on again.
6. Slide the
Power switch
to the OFF position to completely power off the
Surger Plus.
7. Always completely power off the unit, via the
Power switch
, after each
use.
10
Surger Plus
User Manual Lifepro
SoarFX Collection
11
