11
4. Seat Sliding Tube, Back/Seat Support Bracket, and Handlebar
Installation
Remove eight Ø8xØ16x1.5 Washers (36) and eight M8x15 Bolts (72) from the Seat Sliding
Tube (52). Remove bolts with the S6 Allen Wrench provided.
Insert the Seat Sliding Tube (52) into the Bushings (61) of the Rear Main Frame (46).
Attach the Seat Sliding Tube (52) to the Back and Seat Support Bracket (53) with eight
Ø8xØ16x1.5 Washers (36) and eight M8x15 Bolts (72) that were removed. Tighten bolts
with the S6 Allen Wrench provided.
Adjust the seat position and insert the Round Knob (60) and Triangle Knob (23). Turn the
Round Knob (60) and Triangle Knob (23) in the clockwise direction to tighten.
Attach the Handlebar (68) onto the Back and Seat Support Bracket (53) with two M8x45
Bolts (57), two Ø8xØ20x2 Curve Washers (40), two Ø8xØ20x2 Big Washers (45), and two
M8 Cap Nuts (77). Tighten nuts with the Multi Hex Tool with Phillips Screwdriver provided.
Connect the Middle Section Hand Pulse Sensor Wires (8) from the Rear Main Frame (46) to
the Hand Pulse Sensor Wires (56) from the Handlebar (68).
Hardware:
2 Curve Washers
(Ø8xØ20x2)
2 Big Washers
(Ø8xØ20x2)
2 Bolts (M8x45)
2 Cap Nuts (M8)
Multi Hex Tool with Phillips Screwdriver
S10, S13, S14, S15
Tool:
Allen Wrench S6
52
23
60
72
36
36
72
72
36
77
45
36
72
53
68
57
40
46
8
61
56
