LifeCore Fitness LC-1050RBs, User'S Product Manual

Page: 11 / 30

Page | 10
Step 10: Seat Handle Bar Assembly
Tool needed:
6mm Allen wrench
Note: Apply blue loctite to the threads of
each bolt.
A. Remove the preinstalled bolts (A59) and
washers (A33) from the seat frame (A37).
Additional assistance may be needed to
help stabilize handle bar assembly.
B. As shown in Figure 10) Assemble right
handle bar to the seat frame using bolts
(A59) and washers (A33). Using a 6mm
Allen wrench, tighten bolts firm.
C. After the handle bars are assembled,
connect the pulse sensor wires (F16) &
(F18) to sensor wires (F17). (
See figure
to the right )
C. Insert & store excess wires back into
handle bar. Be careful not to pinch the
wires.
D. Finally, install cap (A19) into the opening
in the handle bar to prevent the wires
from sliding out.
E. Repeat the same procedures to the left
handle bar assembly.
How to Adjust the Back Pad Angle
Pull the orange handle on the right side of the
seat assembly back to adjust the back pad
angle. Release the handle to lock in place.
How to Adjust the Seat Pad and Back Pad
Angle
Loosen knob (J5) on the left side of seat
assembly by turning it counter-clockwise. Pull
the knob to release the pop pin holding the
seat assembly, this will allow the back
pad/seat pad to adjust into one of three
positions. Adjust according to what feels right
for the user.
After the adjustment has been made, release
the knob and turn the knob clockwise to
tighten. Tighten knob firm to prevent the
assembly from moving.