www.LifeIonizers.com/Support
18
75
M11/M11 UC NG
AMPS AND LITERS PER MINUTE (LPM)
NOTE: the unit must be dispensing water before pressing the buttons.
• Press and hold
“FILTER 1”
&
“FILTER 2”
simultaneously for 5 seconds in order
to enable the display of the Amps & LPM reading indicator light.
• Two numbers will then appear on the indicator.
• The top number is the amps number followed by the digit A.
• The bottom number is the Liters per Minute (LPM) followed by the
digit L.
• Once the LPM is displayed, you can make the necessary adjustment to the
water flow in order to adjust the LPM to the unit. Adjust the LPM by
slowing down water flow to ionizer from the source water:
- Under Counter -
Cold Water Connect
-
Counter Top
-
Faucet Adapter
KEY NOTE: The slower the flow, the stronger the alkaline or acidic
water is produced. We recommend that you set the machine between
a flow of 1.5-2.5LPM.
• For strong 11+pH alkaline or 2.5 pH acid water, we recommend that
the flow rate be set at 1.1-1.5 LPM. Do not set below 1.0 LPM because it
will error out and display E1.
NOTE: Your pH will be determined by your water source. If you’re on
well water, your water is soft, or your TDS is too low, then you might
need a remeneralizing cartridge or a pre-filter to add alkaline minerals
so your unit can ionize properly.
SOUND/VOLUME ADJUSTMENT (F10)
NOTE:
the unit must be dispensing water before pressing the buttons.
To enter the Volume Adjustment please do the following:
• Press and hold the
“MENU”
button for 5 seconds.
• Once you do this “VOL” will appear on the display and below that it will
show a number.
• To increase volume, press and release the
“FILTER 2”
button, to
decrease the volume setting press and release the
“FILTER 1”
button.
NOTE:
FLOW RATE MUST BE SET BEFORE ADJUSTING OR RUNNING YOUR IONIZER.
Set flow rate no higher than 2.5 liters per minute. Anything higher could cause internal damage.
Function Options
Amps & LPM (liters per minute) indicators
Summary of Contents for M11
Page 1: ......
Page 50: ...revised 5 6 15 ...