Step 5
Assemble the Rocker Arms; Moving Arm Pivot Covers
Parts:
Hardware Bag #3
(2, Wave Washers, 2 Large Flat Washers)
(2, Flat Washers)
(2, M10 x 20mm Silver Hex Head Bolts)
(4, 8mm Black Phillips Head Screws)
Tools:
17mm Socket Wrench, Phillips Screwdriver
Slide one large flat washer (4) and one wave washer (5) onto
the user right pivot shaft (F). Slide the washers fully over the
pivot shaft until seated against the pre-installed stop ring (G).
Locate the user right rocker arm assembly (H) marked with an R.
With the top handgrip facing the front of the units slide the right
rocker arm assembly onto the user right pivot shaft until seated
against the washers.
Secure the rocker arm assembly to the pivot shaft using one
flat washer (6) and one M10 x 20mm Silver Hex Head Bolt (7).
Tighten the bolt securely. Repeat the procedure for the left
rocker arm assembly.
Attach the right side upper pivot covers (J) labeled with the letter "R"
over the upright shaft. Snap the covers together and use two 8mm
black Phillips head screws (8) to attach the covers. Repeat for left side.
CAUTION:
There is a different left and right cover.
13
Summary of Contents for X8
Page 12: ...9 2 ASSEMBLY INSTRUCTIONS Parts List ...
Page 13: ...10 ...
