Life Fitness T3, Service Manual

Page: 63 / 67

Section 5 8
6.
Locate a BOTTOM HANDRAIL SPACER (#8). Insert the BOTTOM HANDRAIL
SPACER between the bottom of the HANDRAIL (#4) and the FRAME (B) with the
long taper facing the front of the unit as shown. Align the two mounting holes in the
HANDRAIL, BOTTOM HANDRAIL SPACER, and FRAME and insert two LONG
MOUNTING BOLTS (#7) and tighten securely using a 5/32” hex key wrench.
7. After securing the USER RIGHT SIDE HANDRAIL (#4 or #11) to the USER
RIGHT UPRIGHT (#2), remove the USER LEFT UPRIGHT rear mounting
bolt and carefully twist THE USER LEFT UPRIGHT (#1) outward until the
rear mounting flange is off of the FRAME (B).
NOTE: BE CAREFUL NOT TO TILT THE USER LEFT UPRIGHT (#1) FROM
UNDER THE DISPLAY CONSOLE (#3) WHEN TWISTING THE USER LEFT
UPRIGHT OUTWARD.
Reach a finger up into the ACCESS HOLE (E) located under the USER
LEFT UPRIGHT mounting flange and guide the 10-PIN CONNECTOR
(10P) of the WIRE HARNESS (C) that was fed into the USER LEFT
UPRIGHT through the BOTTOM CABLE ROUTING HOLE (F) of the
USER LEFT UPRIGHT. Carefully pull the excess wire from within the
USER LEFT UPRIGHT. Plug the 10-PIN CONNECTOR into the CONTROL
BOARD (G) located in the MOTOR COMPARTMENT (H). Feed any excess
wire back into the USER LEFT UPRIGHT.
NOTE: BE CAREFUL NOT TO DAMAGE THE WIRE HARNESS (C)
WHEN PULLING IT THROUGH THE BOTTOM CABLE ROUTING HOLE
(F) IN THE USER LEFT UPRIGHT (#1).
8.
Carefully twist the USER LEFT UPRIGHT back into position on the FRAME
(B) and re-insert the rear MOUNTING BOLT (#10). Tighten the BOLT using
a 9/16” combination wrench until snug and then back it off 1/4 turn.
NOTE: BE CAREFUL NOT TO DAMAGE THE WIRE HARNESS (C)
WHEN TWISTING THE USER LEFT UPRIGHT (#1) BACK INTO
POSITION.
9.
Repeat Step 4 for Models T3 and T3i or Steps 5 and 6 for Models T5 and
T5i to assemble the USER RIGHT HANDRAIL.
For Models T5 and T5i, tighten all five mounting bolts and then back them off one
full turn.
4
7
8
B
1
D
3
B
C
1
10P
G
H
E