Life & Mobility MyPlus, User Manual

Page: 21 / 55

EN14 EN15
Inspired by life
Settings and adjustments
Folding the wheelchair
EN15
Note: Lay the wheel down axle-side up, so
that the axle does not become dirty or
damaged.
6. Place your hand around the middle tube (A)
of the folding frame
7. Pull the frame upwards so that the sides
move towards each other.
Removing and replacing the headrest*
1. Loosen the star knob.
2. Remove the headrest.
3. Insert the headrest in the holder.
4. Retighten the star knob.
Inflating the tyres
The tyres can be inflated using a bicycle pump.
You received a valve nipple with the wheelchair
that you can use to connect a pump. The correct
tyre pressure is shown on the tyres.
To use the wheelchair comfortably, that is to
say with the lowest possible rolling and turning
resistance, it is important that the tyres are at
the right pressure. The wheelchair will be more
difficult to propel and manoeuvre if the tyre
pressure is too low.
Recommendation
To not jeopardise the guarantee, the manu-
facturer recommends having the dealer carry
out these settings.
Headrest
* if applicable
Settings and adjustments
EN14
Adjusting the lower leg length
1. Unscrew the socket screw (A) one turn.
2. Set the legrest to the required lower leg
length.
Note: Ensure that the legrest is at least 5 cm
from the floor.
3. Retighten the socket screw.
Locking the position of the ankle hinge
n
Adjust the ankle angle to the required
position.
n
Drill a hole in the hinge (A).
n
Fix the ankle hinge using the fixing pin
provided.
Removing and replacing the backrest
1. Simultaneously pull the left and right buttons
(A) of the top fittings upwards.
2. Rotate the backrest forwards so that the U
profile is separated from the back cams.
3. Release the buttons of the top fittings.
4. Remove the backrest upwards.
Note:
n
Always check whether the backrest is correctly
attached before you sit in the wheelchair.
Removing and replacing the seat
1. Pull up the front of the seat.
2. Lift the seat out of the frame.
3. With a fixed inner frame, unscrew 4 screws.
Folding the frame*
1. To be able to transport the wheelchair by car,
you can fold the frame.
2. Remove the seat.
3. Remove the backrest.
4. Lift the legrests out of the frame.
5. If necessary also remove the wheels.
Lower leg length
Ankle angle
Backrest
Seat
* if applicable
A
A
A
A