31
Maintenance
MAINTENANCE SCHEDULE
PROCEDURE
TIME
Engine Oil Check
Each Use
Replace Engine Oil
After Each 40 Hours of Use (For Initial Break in
–
After First (1
st
)
10 Hours of Use
Air Cleaner Filter
Check Each Use/Replace As Needed or After Every 100 Hours of
Use
Impeller Check
After 300 Hours of Use or After First Year
Air Cleaner Wash
When Needed/ Maximum 100 hrs run time
Spark Plug
When Needed
Valve Clearance
Check & Re-
adjust annually or after 300 Hours of Use
Fuel Tank
Replace Every 3 Years Based on Condition
NOTE:
Refer to Following Procedures for Proper Method to Perform Maintenance
NOTE:
Follow manufacturers service procedures for high pressure pump.
AR industrial triplex plunger and axial high pressure pumps use SAE30 Non-detergent Mineral Pump oil. This is
specially formulated oil for use in high pressure plunger pumps.
Establishing a regular crankcase oil change schedule is one of the most important steps in preventive
maintenance and to assure long pump life. Change initial fill after 50 hrs. of operation. Thereafter change every 3
months or at 500 hr. intervals (depending on usage). Failure to follow these requirements could void the pump
warranty. PLEASE RECYCLE: Return USED oil to collection center.
Recommended Oil
Available from Lifan Power USA
Call 1-866-471-7464 Option 2 for Parts and Service
Summary of Contents for LFQ3690-CA
