LIFAN Power USA
2205 Industrial Park Road
Van Buren, AR 72956
866-‐471-‐7464
www.lifanpowerusa.com
29
Maintenance
(continued)
FUEL SYSTEM MAINTENANCE:
Refer to Controls and Features section for diagram.
NOTE:
Periodically you can get sediment or trash in your Carburetor Bowl. Use the
following procedures to clean:
1.
Turn the fuel valve to the “OFF” Position.
2.
Remove the Maintenance Access Cover.
3.
Remove the carburetor bowl by removing the mounting bolt located at the
bottom of the bowl.
4.
Dump out the old fuel and sediment into an approved container and clean
carburetor bowl thoroughly.
5.
Fit a new rubber washer into place and re-‐attach fuel bowl to the carburetor.
NOTE: Removal of the drain screw at the bottom of the bowl can drain the fuel to
remove smaller debris that has collected in the bowl.
6.
After bowl is securely back in place, turn the fuel Valve to the “ON” position for
use.
7.
Units equipped with a pre-‐filter for fuel will have a filter housed just below the
fuel cock. Remove the fuel filter element (refer to “Fuel Filter Element Removal”
diagram below) and either clean or replace the fuel filter element. Re-‐assemble
the fuel filter element (refer to “Fuel Filter Element Assembly” diagram below.)
Fuel Filter Element Removal Fuel Filter Element Assembly
8.
Reinstall Left Access Panel.
