11
Lifa Air Oy Ltd.
• Vellamonkatu 30 B, 00550 Helsinki, Finland • Tel: +358 9 394 858
1. Transportation
Before installation and use, check that all the parts look clean and unharmed. Insure that none of
them have been damaged during transport. Lifa Duct Control Cleaning Robot must be protected
from moisture and must not be stored unprotected outside. Please, take care when
packing/unpacking the equipment.
2. Operating position
Place Lifa Duct Control Cleaning Robot on a stable surface. Protect the equipment from vibration
and other agitation. The permitted operating temperature is ranging from 0ºC to +50ºC.
3. Electrical connection
Lifa Duct Control Cleaning Robot requires a power supply (12V DC) that is the battery of Duct Control
Manual or Mini. When switching on the central box of Duct Control Manual or Mini a red light at the
central box will light up if the power supply is OK. The battery at Duct Control Manual or Mini central
box must be charged with a CE-marked charger that is connected to single-phase current 110/230
V 50/60 Hz. Please check that the mains for the charger is suitable! Please read also the user
instructions of Lifa Duct Control Manual or Mini.
4. Fastening of the cables at Duct Control Mini or Manual
Loosen the Cable winder by unscrewing the central screw at the case lid. Connect the joystick cable
and the video/steering cable to the Central Box. Connect the video/steering cable to the Duct Control
Cleaning Robot. Connect the TFT monitor cable to the Central Box of Duct Control Manual or Mini.
Check that all plugs are fastened properly, but do not over tighten the locking collar because of risk
of damage to connector/connections. Do not use pliers/tongs!!!
5. Switch the power on to the Duct Control Mini or Manual
6. Switch on the
camera’s LED lamps
Driving lights is turned on by switching the light control knob on the joystick box.
