LH ”I
NTELLITRAM
” 500 O
PERATORS MANUAL
E
NCODE
LH A
GRO
15
DRILL SHAFT
The drill shaft warning is given if the drill shaft stops rotating.
Encode whether the warning is active (
on
) or not active (
off
). Use the program
keys 1 & 2 to switch the warning on or off.
On most seed drills the drill shaft can be adjusted to rotate very slowly (1 rev. per
100 m). For the clutch and drill shaft warnings the minimum speed per minute is
set to 0.6. the time that passes from when the pulses stop to the warning is given
is directly dependant on the number of pulses per revolution given from the drill
shaft sensor. The more pulses given per revolution will therefore give a faster
warning. An RPM sensor that gives 12 pulses per revolution will be suitable for
seed drills with such a slow drill shaft.
EMPTY HOPPER
If the seed hopper is fitted with an empty hopper sensor a warning will be given
when the hopper is empty.
Encode whether the warning is active (
on
) or not active (
off
). Use the program
keys 1 & 2 to switch the warning on or off.
KG LEFT
The Kg left warning is given is lower than the amount encoded.
Encode whether the warning is active (
on
) or not active (
off
). Use the program
keys 1 & 2 to switch the warning on or off.
The amount, at which the warning should be given, is encoded as kg.
FAN SPEED
The fan speed warning is given when the fan speed is lower than the encoded
speed.
Encode whether the warning is active (
on
) or not active (
off
). Use the program
keys 1 & 2 to switch the warning on or off.
The fan speed, at which the warning should be given, is encoded as RPM.
MACHINE SETTINGS
WORKING WIDTH
The working width of the seed drill encoded in centimetres.
