LGMG AS1930, Operation And Safety Manual

Page: 40 / 109

LGMG North America Inc.
Operation and Safety Manual
32
7.12 Using the Safety Prop
1)
Elevate the platform a specified height above
the ground (for elevation height, refer to the
following table).
Model Height
SS1230E
7.9ft (2.4m)
SS1432E
AS1930
AS1930E
AS1932
AS1932E
SS1932E 9.09ft (2.77m)
AS2632
10.5ft (3.2m)
AS2632E
AS2646
AS2646E
AS3246
AS3246E
AS4046
13.1ft (4m)
AS4046E
AS4650
AS4650E
2) Lift the safety prop, move it to the center of
the scissor cross tube and rotate it upward
until it is vertical.
3) Lower the platform height until the safety
prop completely contacts the shaft tube.
Keep the platform away from the movable
parts during the lowering process.
△
!
Danger
Do not carry any load in the platform
when the safety prop is being used. No
long time (8 hours) to use safety prop in
empty state.
7.13 How to Stow the
Guardrail
.On models SS1230E/SS1432E/SS1932E/
AS1930/AS1930E/AS1932 / AS1932E/
AS2632/AS2632E, the platform guardrail
system consists of a folding guardrail on an
extended platform and a folding guardrail on
the main platform.
1)
Fully lower the platform and lock it into the
extended platform.
2) Remove the platform controller.
3)
Remove the M-shaped fixed seat between
the guardrails of the main platform and the
extended platform from the inside of the
platform and place it in the platform.
4)
Remove the two retaining pins at the front of
the extended platform from the inside of the
main platform.
5)
Fold the front guardrail of the extended
platform inward. Do not place your hands in
places where there may be a pinch point. At
the same time, prevent the left and right
guardrails of the extended platform from
tilting over.
6)
Install the two retaining pins which were
removed back to the guardrail on each side.
7)
Fold the left guardrail of the extending