LGMG AS1930, Operation And Safety Manual

Page: 30 / 109

LGMG North America Inc.
Operation and Safety Manual
22
Chapter 6 Function Test
△
!
Warning
Operation is forbidden unless the
following safe operating principles of
the machine are understood and
performed.
1) All dangerous work site conditions are
avoided.
2)
Pre-Operation Inspection has been
completed.
3) The workstation has been inspected.
4) The function test has been performed prior
to any operation.
△
!
Notice
The function test must be performed
and proper operating procedures
understood before the next step.
5) The machine is used as described in this
manual.
6.1 General Information
1) The purpose of the Function Test is to
identify potential component failure before
operating the machine.
2) The operator must test all machine functions
as outlined in this section.
3) Do not use a damaged or malfunctioning
machine. Tag out the control boxes and do
not use the machine until repairs have been
made.
4) Only qualified maintenance technicians are
permitted to repair the machine as per the
regulations of the manufacturer.
5) After repairs or maintenance have been
performed, the operator must perform out the
Pre-Operation inspection and Functional
Test again before operating the machine.
6.2 Function Test
1) Carry out the function test on a firm and level
surface with no barriers or obstructions.
2) Ensure the battery pack is connected.
6.3 Tests from the Ground
Controls
1) Pull out the red emergency stop buttons on
the platform controller and the ground
controller to the ON position.
2) Turn the key switch to the ground controller
position.
3) Observe the LED display on the platform
controller for the proper reading.