7
TROUBLESHOOTING
WARNING
Electrical Shock and Personal Injury Hazard
• Unplug the vacuum cleaner before servicing or cleaning the unit. Failure to do so could result in electrical
shock or personal injury.
Review the chart below for possible solutions in the event of a minor problem. Any service needed, beyond the
procedures described below and elsewhere in this manual, should be performed by an authorised service centre.
Problem
Vacuum cleaner
won’t run
Vacuum cleaner
won’t pick up
Dust escaping
the dust
container
Possible Cause
1. Not plugged firmly into wall outlet
2. No voltage in wall outlet
3. On/Off switch not turned on
4. Blown fuse in the plug
5. Thermal overload protection
activated
1. Belt worn or broken
2. Worn agitator brush
3. Dust container full
4. Hose or nozzle blocked
5. Hose damaged
6. Dust container installed incorrectly
7. Belt not installed on the motor shaft
1. Dust container installed incorrectly
2. Pre-motor filter cap installed
incorrectly
Possible Solution
1. Plug firmly into wall outlet.
2. Check fuse or circuit breaker.
3. Press the On/Off switch.
4. Change the fuse for a 13 Amp ASTA approve fuse.
5. Turn the vacuum cleaner off, unplug it, and allow it
to cool. (See page 3)
1. Replace the belt.
2. Replace the agitator.
3. Empty the dust container and check the pre-motor
filter.
4. See REMOVING BLOCKAGES on page 8.
5. Replace the hose.
6. Make sure the dust container is seated properly in
the handle.
7. Install the belt on the motor shaft. (See page 16.)
1. Make sure the dust container is seated properly in
the handle.
2. Make sure the pre-motor filter is in place and
seated correctly.
LGE Internal Use Only
Copyright © 200
7
LG Electronics. Inc. All right reserved.
Only for training and service purposes
Summary of Contents for VUP152NJP
Page 17: ...P NO 3828FI5874B ...
