4
Installation
Installation (RNOE-B501A)
Part Names and Functions
a
Lens Cap
b
Lens iris output connector (LENS)
This 4- pin connector is used to send the Iris control signal and power
supply to an auto-iris type lens.
c
Camera installation hole
d
PWR (Power indicator)
Lights when the camera is powered.
e
ABF
ABF ( AUTO Back Focus ) is an adjustable function of the back focus
automatically.
f
Power input terminal
Connects to DC 12 V or AC 24 V power supply using proper cables.
This camera must always be operated DC 12 V or AC 24 V. Certified/
Listed Adaptor which comply with LPS.
g
ETHERNET/PoE Port
Connects to a PC or a network via a hub with a 10 BASE-T/100
BASE-TX cable attached RJ-45 connector.
Note:
Power over Ethernet (PoE) is a technology that integrates power
into a standard LAN infrastructure. It enables power to be provided
to the network device, such as a network camera, using the same
cable as that used for network connection. It eliminates the need for
power outlets at the device locations and enables easier application
of uninterruptible power supplies (LPS).
h
SD card slot
i
AUDIO IN
Input for a mono microphone, or a line-in mono signal.
j
AUDIO OUT
Connect to an active speaker with a built-in amplifier.
k
External device connectors
•
ALARM OUT (1A/1B) Terminals: Provides physical interface for
Alarm/Relay.
•
ALARM IN (1/2) Terminals: Provides physical interface for sensor.
•
ALARM IN (3) Terminals: External Day/Night fucntion is supported
as using ALARM IN.
•
RS232 (RX/TX): RS232 is not used (Only for technical specialist).
•
RS-485 (A/B): Connect an external PTZ device.
l
VIDEO OUT
Connect the video signal between the IP camera and the monitor.
m
RST (RESET button)
Push the button more than 5 seconds, this would restore the factory
default network related settings.
a
c
h
f
g
k
i
j
l
m
d e
b
Summary of Contents for RNOE-B501A
Page 47: ......
