LG Minibeam PH550, Owner'S Manual

Page: 11 / 124

11
SAFETY INSTRUCTIONS
• To prevent damage to lamp,
unit must remain plugged in for
approximately 3 minutes after
power down to allow for proper
cool down (not applicable on
LED models).
• Do not touch the lens; doing so
can result in burns or damage
to lens. Lens and unit may be
HOT during and immediately
after use. Use caution when
handling unit, allowing for proper
cool down.
• Only use a grounded electrical
outlet. (Except for devices which
are not grounded.)
• Do not insert anything into or
cover up the exhaust vents.
– This may result in fire or
electric shock.
• Follow all maintenance
guidelines for optimal use;
service only at an authorized
service center.
•
Lamp contains mercury and
as such must be disposed of
according to local, state, and
federal laws (not applicable on
LED models).
• Keep the batteries and remote
out of reach of children.
– This will prevent personal
injury or damage to the
product.
CAUTION
• Do not use or store the projector
outdoors for long periods of
time.
• Do not mix new batteries with
old ones.
– Burst or leaking batteries
may result in damage or
injury.
• Be sure to unplug if the projector
is not to be used for a long
period.
– Accumulated dust may result
in fire or electric shock due to
overheating, ignition, or poor
insulation.
• Only use the specified type of
battery.
– Burst or leaking batteries
may result in damage or
injury.
• Make sure you use the same
type of battery when replacing.
– In the case of a battery
contact failure, the battery
may drain quickly or the
remote control may not work
properly.
• Dispose of used batteries
properly.
– This may result in explosion
or fire. The correct method of
disposal may vary depending
on your country or region.
Dispose of the battery pack
as instructed.