LG LSN5AT5M, Owner'S Manual

Page: 34 / 44

FLARING WORK AND CONNE CTION OF PIPING
Connec tion of piping-
Indoor
Preparing the indoor unit's piping and drain
hose for installation through the wall.
Remove the plastic tubing retainer (see
illustration below) and pull the tubing and
drain hose away from chassis.
Replace the plastic tubing holder in the
original position.
C
T ape the tubing, drain hose and the connecting
cable. Be sur e that the drain hose is locat ed at
the lowest side of the bundle. Locating at the
upper side can cause drain pan t o overflow
inside the unit.
*Foamed polyethylene or equivalent is recommended.
Loop
Connecting
cable
Drain hose
Gas side
piping
Liquid side
piping
Tubing holder
T o remove the holder ,
press the bottom of
chassis near the holder
upward and pull the tab
out of its hole.
D
Indoor unit installation
Hook the indoor unit onto the upper portion of
the installation plate.(Engage the two hooks of
the rear top of the indoor unit with the upper
edge of the installation plate.) Ensure that the
hooks are properly seated on the installation
plate by moving it left and right
A
Rout e the indoor tubing and the drain hose
in the direction of r ear left.
Drain hose
B
Insert the connecting cable into the indoor
unit fr om the outdoor unit thr ough the
piping hole.
Do not connect the cable to the indoor unit.
Ma ke a s ma ll lo op wit h th e c ab le fo r e as y
co nn ec tio n la te r.
For left r ear piping
CAUTION
When install, make sure
that the remaining parts
must be removed clearly
so as not to damage the
piping and drain hose,
es pe cia lly po we r co rd
and connecting cable.
Pre ss th e lo we r le ft an d r ig ht sid es of th e
un it ag ain st th e in sta lla tio n p la te un til th e
ho ok s e ng ag e in to th eir slo ts (c lic kin g-s ou nd ).
E
Connecting the pipings to the indoor unit and
drain hose t o drain pipe.
Ali gn th e c en te r o f th e p ip in gs an d s uff ic ie ntl y
tig hte n th e fl are nu t b y h an d.
Indoor unit tubing Flare nut Pipings
Drain hose
Connecting
cable
INSTALL ATION
11
If the drain hose is routed inside the room,
insulate the hose with an insulation material* so
that dripping from "sweating"(condensation) will
not damage furniture or floors.