LG LRSC21934SW, Service Manual

Page: 22 / 129

HOW TO INSTALL REFRIGERATOR
■
Install Water Filter (Applicable to some models only)
■
Before Installing water filter
1. Before installing the filter, take out the top shelf of the
refrigerator after tilting it to the direction ( ) and lifting it
to the direction ( ) and move it to the lower part.
2. Remove the lamp cover by pressing the protrusion
under the cover and pulling the cover to the front.
■
Installing water filter
1. Initial installation of water filter
Remove the filter substitute cap by turning it
counterclockwise (
) by 90 degrees and pulling it down.
Note : Keep it safe to use it later when you do not use the
filter.
Remove the red cap from the filter and attach the
sticker. Insert the upper part of the filter (
) after
aligning with the guideline marked on the control box,
and fasten it by turning it clockwise by 90 degrees.
Note : Check that the guideline and the fastening
indication line are aligned.
2. Replacement of water filter
While holding the lower part of the filter, turn it
counterclockwise (
) by 90 degrees and pull it down.
Note : Check that the guideline and the loosening
indication line are aligned.
■
After installing water filter
Reassemble the lamp cover and the top shelf of the
refrigerator. To place the top shelf of the refrigerator, raise
the front part of the shelf a bit so that the hook of the shelf
is fit into the groove.
In order to clean the water filter system, drain water for
about 3 min.
Note : Then open the door of the refrigerator and check for
water droppings on the shelf under the filter.
Control box
Aligning with the guide line
and the fastening indication line
Control box
Aligning with the guide line
and the loosening indication line
Separation
of red cap
Adhesion
sticker
Substitute
cap
- 22 -