9
IMPORTANT SAFETY INSTRUCTIONS
ENGLISH
SAFETY WHEN CLEANING
•
Open a window or turn on a ventilation fan or hood before self-cleaning.
•
If the oven is heavily soiled with oil, self-clean the oven before using the oven again. The
oil could cause a fire.
•
Do not use oven cleaners.
Commercial oven cleaner or oven liner protective coating of
any kind should not be used in or around any part of the oven.
•
Never pour cold water over a hot oven for cleaning. Doing so may cause the oven to
malfunction.
•
Make sure oven lights are cool before cleaning.
•
Do not clean door gasket.
The door gasket is essential for a good seal. Care should be
taken not to rub, damage, or move the gasket.
•
Excess spillage must be removed before cleaning.
•
Steam cleaner is not to be used.
COOK MEAT AND POULTRY THOROUGHLY
•
To protect against food-borne illnesses, cook meat and poultry thoroughly. The USDA has
indicated the following as safe minimum internal temperatures for consumption:
•
Ground beef: 160 °F (71.1 °C)
•
Poultry: 165 °F (73.9 °C)
•
Beef, veal, pork, or lamb: 145 °F (62.8 °C)
•
Fish/seafood: 145 °F (62.8 °C)
Using Oven Racks
•
The racks have a turned-up back edge that prevents them from being pulled out of the
oven cavity.
•
When removing racks, pull the rack straight out until it stops, and lift up the front of the
rack and pull it out.
•
When replacing racks, place the end of the rack on the support, and tilt the front end up
and push the rack in.
CAUTION
•
Replace oven racks before turning the oven on to prevent burns.
•
Do not cover the racks with aluminum foil, or any other material, or place anything on
the bottom of the oven. Doing so will result in poor baking and may damage the oven
bottom.
•
Only arrange oven racks when the oven is cool.
Installation Guide for Flicker (EN 61000-3-3 & EN 61000-3-11)
•
This device is intended for the connection to a power supply system with a maximum
permissible system impedance Z
MAX
of 0.3117 Ω at the interface point (power service box)
of the user’s supply. The user has to ensure that this device is connected only to a power
supply system which fulfills the requirement above. If necessary, the user can ask the
public power supply company for the system impedance at the interface point.
Summary of Contents for LRE3163 Series
Page 93: ...47 Memo Español Memo ...
Page 94: ...48 Memo Memo ...
Page 95: ...49 Memo Español Memo ...
Page 96: ...Printed in Mexico ...
