16
BEFORE USING FOR THE FIRST TIME
• Do not pour any detergent in the water softener. It may cause a malfunction.
WARNING
Step 3. Salt Filling
(Hard water requires salt filling)
Salt
W
ate
r
Salt filling must be made before starting the washing program. In case of insufficient salt, the ‘Salt
Filling’ light turns on in the display, unless the Hardness level has been set to H0. (refer to page 15)
1) Remove the lower rack and remove the cap of the water
softener placed in the left side of the bottom of the
washing part by rotating it counterclockwise.
2) Before using your dishwasher for the first time, it is
necessary to Pour 1.5kg of salt and 1 litre of water
at the same time if intending to use the water softener
system. Refer to page 15 for Hardness level settings.
(Use a funnel when refilling salt)
3) Wipe off any spilled salt around the water softener.
4) Fasten the cap tightly.
(Loosely fastened cap may cause rust due to salt spilled
into the container.)
5) Run the Quick course without dishes.
• Water softening salt can be purchased from salt distributors.
NOTE
! Check point
- Note for Fastening the Cap of the water softener.
•
Seal the cap properly (by
aligning it horizontally and
turning it clockwise.)
<Wrong assembly>
<Normal assembly>
