27
27
OPERATING SEQUENCE (SUMMARY)
1. Press the Power button.
5. Load the dishes in the basket.
6. Add the proper amount of
detergent.
7. Set and start the program
(the
cycle will start automatically 4 seconds
after any setting is selected)
8. Program ends.
2. Check there is rinse aid and
salt.
3. Open the door and check
the filters
4. Ensure the spray arms can
unobstructedly rotate.
The unit will turn on. Observe the indicators.
Make sure that all dishes do not touch each other.
Take care that the dishes do not obstruct the
rotation of spray arms.
Check the rinse aid and salt refilling indicators. If
the corresponding indicator lights illuminate, refill
the rinse aid and salt. For more information, refer
to page 24.
Always clean the filter either after a wash or
before a wash so that it does not impair the
washing performance.
Ensure that the upper spray arms and the lower
spray arms rotate freely. Remove the spray arm
and clean it if it does not rotate freely.
After the program ends, dry cycle (Cd) will
operate. During this cycle, the dishes can be
removed if you wish. The Cd cycle will be
cancelled when the door is opened.
Salt refilling indicator
Rinse aid refilling indicator
• Do not load any items in upper rack
when the lower rack is pulled out and
loaded. (The dishwasher may tilt to the
front.)
CAUTION
• Empty the lower rack first and then the
upper one. (It will avoid water dripping
from the upper rack onto the dishes
below)
CAUTION
• Do not open the door during operation or
immediately after it has completed the
wash cycle as the steam build up may
cause scalding as the door is opened.
WARNING
