LG JB-Q18GB2A0, Owner'S Manual

Page: 36 / 50

Installation of IR Remote Sensor
15
1. Connect the IR sensor cable
to the CN-DISPLA Y connector
of main PCB Assy.
2. Fix the rear side of the installation boar d with
the screw .
3. No w attach the IR PCB Assy at the rear
side of installation board.
When disassemble the IR remote sensor
from the installation board, use the driv er as
shown in the r ight picture and insert it into the
hole with the arrow . And when you pull the dr iver
in the front direction, the IR remote sensor
will be separated.
The IR sensor cab le is connected as factory default.
Fixate the IR Remote
Sensor cable to
the guide slot.
Use the screws
for fixate the unit
firmly on the w all.
Installation board
<Front side of
installation board>
<Rear side of
installation board>
Bottom
Wall
Side
Wall
Side
Wall
Side
Wall
Side
Wall
Side
Do not install the cable to be 10m or abo ve.
(It can cause communication err or.)
• When installing the extension cable, check the connecting direction of the connector of the IR remote sensor side
and the product side for correct installation.
• If you install the extension cable in the opposite direction, the connector will not be connected.
• Specification of extension cable: AWG 26 (2sim 7shield) or above
Guide slot