58
Outdoor Unit
Installation guide at the seaside
Installation guide at the seaside
1. Air conditioners should not be installed in areas where corrosive gases, such as acid or alkaline gas, are produced.
2. Do not install the product where it could be exposed to sea wind (salty wind) directly. It can result corrosion on the product.
Corrosion, particularly on the condenser and evaporator fins, could cause product malfunction or inefficient performance.
3. If outdoor unit is installed close to the seaside, it should avoid direct exposure to the sea wind. Otherwise it needs additional
anticorrosion treatment on the heat exchanger.
CAUTION
2.1 Selecting the location(Outdoor Unit)
1) If the outdoor unit is to be installed close to the seaside, direct exposure to the sea wind should be avoided.
Install the outdoor unit on the opposite side of the sea wind direction.
2) Select a well-drained place.
Sea wind
Sea wind
h
1. If you can’t meet above guide line in the seaside installation, please contact LG Electronics for the additional anticorrosion treatment.
2. Periodic (more than once/year) cleaning of the dust or salt particles stuck on the heat exchanger by using water.
CAUTION:
Multi V Space should be installed in the special outdoor room with soundproofing walls.
Product information
• Product Name : Air conditioner
• Model Name :
The A-weighted sound pressure emitted by this product is below 70 dB.
** The noise level can vary depending on the site.
The figures quoted are emission level and are not necessarily safe working levels.
Whilst there is a correlation between the emission and exposure levels, this cannot be used reliably to determine whether or not further pre-
cautions are required.
Factor that influence the actual level of exposure of the workforce include the characteristics of the work room and the other sources of
noise, i.e. the number of equipment and other adjacent processes and the length of time for which an operator exposed to the noise. Also,
the permissible exposure level can vary from country to country.
This information, however, will enable the user of the equipment to make a better evaluation of the hazard and risk.
• Additional information : Serial number is refer to the bar code on the product.
Product Sales Name
Model Factory Name
ARUx**Ly2
x = N, B (Heat pump), V (Cooling only)
y = R (Right discharge)
L (Left discharge)
*** = Numeric; (Cooling capacity)
Model Designation
Airborne Noise Emission
