4-12. How to prevent the panel falling out
Whenever you move the set, please try to use the handle on the rear side
If you move the set without using the rear handle, be careful not to touch the front of
the panel (Especially, center of the bottom of panel)
If you touch it strongly, the panel may go into inside of the module
Panel got into the inside
of module (Defect point)
If the panel has got into the inside of the module, please refer to below guide
1
2
Loosen the screws from the near of defect point (5 screw or more)
Lay the back of the set down on the table
Defect point
3
Lift the set using the back handles(4ea) and shake the set up and down slowly
4
Check panel be in good or not and then joint screw again
Example of 55LV75A
Rear side
56
