—6—
1.3 CONTROL LOCATIONS
• OPERATION
ELECTRIC HEATING MODEL
COOLING ONLY MODEL
VENT
CLOSE
VENT
OPEN
TEMPERATURE CONTROL
Set the Thermostat control to the desired temperature
mark 5 (the mid-point is a good starting position). If the
room temperature is not satisfactory after a reasonable
time, adjust the control to a cooler or warmer setting, as
appropriate.
OPERATION MODE SELECTOR
OFF:
Turns air conditioner off.
LOW FAN:
Low speed fan operation without cooling.
HIGH FAN:
High speed fan operation without cooling.
LOW COOL: Cooling with the low speed fan operation.
HIGH COOL: Cooling with the high speed fan operation.
LOW HEAT: Heating with the low speed fan operation.
HIGH HEAT: Heating with the high speed fan operation.
• VENTILATION
The ventilation lever is located to the lower left side of the unit.
The ventilation lever must be in the CLOSE position in order
to maintain the best cooling conditions.
When fresh air is necessary in the room, set the ventilation
lever to the OPEN position.
The damper is opened and outdoor air is drawn into the room.
This will reduce the cooling or heating efficiency.
When the air conditioner has performed a cooling or
heating operation and is turned off or set to the fan
position, wait at least 3 minutes before resetting to the
cooling operation.
A slight heat odor may come from the unit when first
switching to HEAT after the cooling season is over.
This odor, caused by fine dust particles on the heater, will
disappear quickly.
This is harmless.
CAUTION
NOTE
