LIP-8004D User Guide
Issue 1
4 August,
2008
1.5.1 Wiring
Connectors
The LIP-8004D has a single Ethernet port that is
connected to the LAN using a RJ-45 plug terminated
category 5 cable supplied with the Phone. A 2 meter (6
foot) cable is provided for desk mount installation.
Using the cable, one RJ-45 plug is inserted into the
"LAN" jack in the bottom of the Phone. The other RJ-45
plug is inserted into the RJ-45 jack previously wired to
an Ethernet switch port accessible by the MFIM. To
power the LIP Phone over the LAN, the switch port must
support POE (Power over Ethernet) standard 802.3af.
1.5.2 Power
All LIP-8000 series phones can be powered by the
AC/DC Adapter-K- (48 VDC @0.3A) or over the LAN
cable using the POE8 or other 802.3af compliant switch.
If using the AC/DC Adapter, after connecting the Phone
to the LAN, the Adapter’s DC voltage plug is inserted
into the power-input jack in the underside of the Phone.
One end of the AC power cord is inserted into the
mating receptacle of the AC Adapter, and the other end
is inserted into the AC power outlet.
1.5.3 Wall
Mount
The LIP-8000 series phones can be wall mounted as
needed. The following instructions detail how to perform
a wall mount installation:
•
Mark and drill two (2) 7mm holes for plastic wall anchors.
•
Insert the two (2) anchors into the holes and insert and tighten
the each screw leaving about 2.5 mm (1/8-inch) of the screw
exposed.
•
Slide the LIP-8000 phone over the screws and assure the
phone is secure.
•
NOTE—It may be necessary to remove the phone and tighten
or loosen the screws for a secure mounting.
Summary of Contents for iPECS LIP-8004D
Page 1: ...LIP 8004D User Guide ...