Installation
3.12 Making a network cable
Use this method to make a network cable, which is to be connected between
the battery pack and the inverter.
1. Cut cable to needed length.
2. Strip 2.5 to 5 cm of the outer sheath at the end of the cable.
3. Untwist and separate each pair of wires.
4. Arrange the wires in this order:
1) White with an orange stripe
2) Orange
3) White with a green stripe
4) Blue
5) White with a blue stripe
6) Green
7) White with a brown stripe
8) Brown
5. Bring the sorted wires together, and trim them to about 1.4 cm in length.
6. Hold the RJ45 plug with the copper contacts facing up, and insert the wires
into the plug, making sure that they stay aligned and each color goes into
its appropriate channel.
7. Put the plug into a network crimper and squeeze the handles until it clicks.
8. Repeat these steps for the other end of the cable.
25
