6
8. With the help of another person, place the assembly over
the mounting bracket (AA) and anchor bolts (BB). Secure
with the cap nuts (CC) and washers (DD). Tighten with a
1/2 in. wrench (not included).
CAUTION:
Allow the concrete to dry before installing the
pole assembly.
CARE AND MAINTENANCE
To clean, unplug lamp and wipe with a damp, non-abrasive cloth.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
The light will not go on.
1. No power.
2. Fixture may be wired
incorrectly.
3. Switch may be wired
incorrectly.
1. Make sure lamp fixture is
plugged in and power is on.
2. Check wiring.
3. Check wiring.
Fuse blows or circuit trips
when fixture is turned on.
Crossed wires or power wire is
grounding out.
Consult a certified electrician.
The fixture shakes in high
winds.
1. The mounting bracket (AA)
may be
assembledincorrectly.
2. The screws and cap nuts
may be secured incorrectly.
1. Make sure the mounting
bracket (AA) was installed at
ground level.
2. Make sure the screws and cap
nuts were secured tightly.
3-YEAR LIMITED WARRANTY
If this product fails due to a defect in materials or workmanship within three (3) years from the date
of purchase, return it along with proof of date of purchase and it will be replaced with the same or
comparable model free of charge.
This warranty is void if damage or defect has resulted from accident, abuse, misuse or faulty repair.
This warranty gives you specific legal rights and you may have other rights that vary from state to
state.
IN NO EVENT WILL LIABILITY EXTEND TO ANY CONSEQUENTIAL, SPECIAL, INCIDENTAL
OR INDIRECT DAMAGES OF ANY KIND ARISING OUT OF THE USE OR MISUSE OF THIS
PRODUCT. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF
INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE EXCLUSION OR LIMITATION
MAY NOT APPLY TO YOU.
Hardware Used
Cap nut
x 3
Washer
x 3
CC
DD
