Leyard TWF Series, User Manual

Page: 38 / 76

~ 33 ~
User Manual for TWF Series LED Unit
IV. Guidelines for Operation of Software
When display units are mounted and cables connected for a piece of screen, the next work is to configure
it via software. Steps
①
~
⑥
show the operations for splicing a screen with standard resolution. Initial
steps
①
,
②
and
③
must be followed in sequence to make successful setting. Steps
④
,
⑤
and
⑥
are to set the uniform parameters of the screen, so they may not be done in sequence. Step
⑦
is to debug
the whole screen. Steps 8 and 9 are optional.
①
Establish communication between a computer and the first display unit (the one at the lower
right corner of the screen when you face the screen) of a joined screen with standard
resolution;
②
Configure a proper IP address (in the "Setup" page) for the display unit which is connected to
RJ45 network cable;
③
Configure the joining of display units with standard resolution (in the "Setup" page);
④
Configure HDMI input, frequency, display mode, brightness and color temperature (in the
"Basic Controls" page);
⑤
Correct switch settings(on “Basic Controls” page);
⑥
GAMMA adjustment (on “Advanced Controls” page);
⑦
Set the full-screen controls after the splicing setting of the display unit within each standard
resolution is completed. Enter the start and end IPs in the communication settings field, adjust
the full-screen brightness, and test the full-screen control (on “Basic Controls” page);
⑧
Seam Correction, optional.
⑨
If LED module is replaced, the operation “reading calibration data from the lamp panel back
to the main panel”(Seam Correction) should be conducted as an optional operation.
c
b
d
e
a