Leyard Tocuhboards Planar UltraRes Series, User Manual

Page: 53 / 88

Advanced Settings Menu
Planar UltraRes Series User Manual 49
Power Submenu
Auto Power On
Set whether the system will automatically leave standby mode after AC power is applied
Options: On, Off; Default: Off
Power Saving Mode
Set the action to take if there is no signal detected after the period of time selected by
the Power Saving Delay setting:
•
Disabled: The display will remain on even if no signal is present.
• Low Power: The display will enter standby mode if no signal is detected after the
specified period of time.
• Wake on Signal: The display will enter a reduced power mode if no signal is
detected after the specified period of time. When in this state, the display will turn
on when a signal is detected or when any key is pressed on the keypad or IR remote.
Power Saving Delay
Set the number of minutes to delay before initiating the power saving mode action (if
any)
Options: 1 Minute, 5 Minutes, 15 Minutes, 30 Minutes, 60 Minutes; Default: 5 minutes
Power On Delay
Select the amount of time to delay before turning on the display
Options: 0-10 seconds, in 0.1 second increments; Default: 0 seconds
OPS Power Down Check
When this is enabled, the system will wait for a signal from the OPS module indicating it
has finished its power down sequence before going into standby
Options: Disable, Enable; Default: Enable