Lexmark C520 Series, Service Manual

Page: 70 / 259

2-12
Service Manual
5022- xxx
37 xx Insufficient memory,
some held jobs were lost • The printer was unable to restore some or all of the confidential or held
jobs on the hard disk.
• Press until
Continue
appears, and then press to clear the
message.
• If this message occurs again, replace the hard drive.
• If this does not fix the problem, replace system card. Go to
“System
card removal” on page 4-47 .
38 xx Memory Full • Press until
Continue
appears, and then press to clear the
message and continue printing.
The job may not print correctly.
• Cancel the current job.
• Install additional printer memory.
• If this does not fix the problem, replace system card. Go to “System
card removal” on page 4-47 .
50 xx PPDS font error • Press until
Continue
appears, and then press to clear the
message and continue printing.
The job may not print correctly.
• Cancel the current job.
• If this does not fix the problem, replace system card. Go to
“System
card removal” on page 4-47 .
51 xx Defective flash detected • Press until
Continue
appears, and then press to clear the
message and continue printing.
• Install different flash memory before downloading any resources to flash.
• If this does not fix the problem, replace system card. Go to
“System
card removal” on page 4-47 .
52 xx Not enough free space
in flash memory for
resources • Press until
Continue
appears, and then press to clear the
message and continue printing.
Downloaded fonts and macros not previously stored in flash memory are
deleted.
• Delete fonts, macros, and other data stored in flash memory.
• Install a larger capacity flash memory card.
• If this does not fix the problem, replace system card. Go to
“System
card removal” on page 4-47 .
53 xx Unformatted flash
detected • Press until
Continue
appears, and then press to clear the
message and continue printing.
• Format the flash memory before storing any resources on it. If the error
message remains, replace the flash memory.
• If this does not fix the problem, replace system card. Go to “System
card removal” on page 4-47 .
54 xx Serial option <x> error • Make sure the serial link is set up correctly, and the appropriate cable is
in use.
• Make sure the serial interface parameters (protocol, baud, parity, and
data bits) are set correctly on the printer and host computer.
• Press until
Continue
appears, and then press to clear the
message and continue printing.
The job may not print correctly.
• POR the printer. If this does not fix the problem, replace system card. Go
to “System card removal” on page 4-47 .
54 xx Network <x> software
error • Press until
Continue
appears, and then press to clear the
message and continue printing.
The job may not print correctly.
• Program new firmware for the network interface.
• POR the printer. If this does not fix the problem, replace system card. Go
to “System card removal” on page 4-47 .
Error
code Sub
code
Primary message Action