Lexmark 25**-100, Service Manual

Page: 78 / 188

4-4
Service Manual
25XX-100, -110
11. After confirming that the head gap is within the specified range
for all printhead positions (left, right and center), apply the
thread sealer to both bushings.
Bidirectional print adjustment
After replacing any mechanical part which affects the operation of
the logic board or the carrier, perform the following procedure to
adjust the bidirectional print. This adjustment cannot be completed if
the printer runs out of paper, so be sure to use continuous forms.
1. Through the Setup Menu, be sure the default macro is set to
disabled.
2. Turn the printer off.
3. Open the operator panel cover to access layer two.
4. Press and hold the Pitch key while turning the printer on.
— The draft alignment bars print.
— The current value is the number printed below the bars.
5. To set draft, select the best alignment from the alignment bars
in rows 01—11.
6. Press Micro
↑
or Micro
↓
to select the best alignment by
number, or keep the current value. After selecting, the printer
prints a single row showing the current alignment setting.
7. Press Set TOF to save the selection.
— The printer automatically prints the alignment bars for NLQ.
— The current value is the number printed below the bars.
8. To set NLQ, select the best alignment from the alignment bars
in rows 01—11. The current value is the number printed below
the bar.
9. Press Micro
↑
or Micro
↓
to select the best alignment by
number, or keep the current value. After selecting, the printer
prints a single row showing the current alignment setting.
10. Press Set TOF to save the selection.
11. Close the operator panel cover. The printer returns to Ready.
Removal procedures
CAUTION: Be sure to unplug the power cord whenever you
are working on the printer with one of the covers removed.