Lexmark 25**-100, Service Manual

Page: 17 / 188

General information
1-5
25XX-100, -110
Setting Top-of-form (continuous-pull mode)
1. Turn the printer on. The Paper Out light blinks if no paper is
loaded.
2. Move the Paper Select lever down to the continuous forms
position.
3. Load continuous form paper on the pull tractor feed pins.
4. Open the operator panel cover to access layer two.
5. Press any paper movement button ( LineFeed , Micro
↑ ,
or
Micro
↓
) to move the paper to the Top-of-form position.
6. Use the second sheet of continuous forms to set Top-of-form.
7. Press Set TOF to set and save Top-of-form.
8. Close the operator panel cover. Top-of-form is not saved if the
printer is turned off, or if it runs out of paper when the printer is
in Pull Tractor mode.
9. Press Start/Stop to set the printer online.
Setting Top-of-form (cut forms, envelopes)
Top-of-form can range from minus 1 to plus 22 inches from the top
of cut sheet paper. To set and save Top-of-form:
1. Turn the printer on. The Paper Out light blinks if no paper is
loaded. If the Paper Out light is off, tear off excess forms and
press
Load/Unload . If an individual form is loaded, press
FormFeed to clear the paper path.
2. Move the paper select lever up to the cut forms position.
3. Load a cut sheet of paper or envelope through the manual feed
door. The printer moves the paper or envelope to the current
Top-of-form if Auto Cut Sheet is set to on. If not, press
FormFeed when the Paper Out light goes off.
4. Open the operator panel cover to access layer two.
5. Press any paper movement button ( LineFeed , Micro
↑ ,
or
Micro
↓
) to align the horizontal lines (located on the platen) with
the Top-of-form you want.
6. Press Set TOF to set and save Top-of-form.
7. Close the operator panel cover.
8. Press Start/Stop to set the printer online.