Lexicon 300L -, Owner'S Manual

Page: 9 / 162

Lexicon
1-2
300L Owner's Manual
Mounting
Before rack-mounting the 300L, you may want to remove the four rubber feet
attached to the bottom of the chassis. Gently pry off the black plastic buttons in
the center of each foot, then remove the foot itself.
The 300L measures 19"W x 3.50"H x 13.9"D (483 x 90 x 353 mm). It uses two
EIA-standard rack spaces and can be mounted on any level surface or in a
standard 19 inch (483 mm) rack. Whatever mounting method you use, make
sure that the 300L is securely screwed into the rack adapter If the 300L is
mounted in a rack or road case, support the rear of the chassis to prevent
possible damage from mechanical shock and vibration.
Power Requirements
The 300L is equipped with a 3-pin IEC power connector and detachable cord,
providing chassis grounding to the AC mains line. Plug the female end of the
power cord into the 300, and the male end into a wall outlet.
The 300L is internally wired to operate at 100, 120, or 230 VAC. The operating
voltage set at the factory is marked on a label attached to the rear panel. Check
the label
before applying power to the unit.
If the voltage must be changed, refer a qualified technician to the Voltage
Changeover procedure in the 300L Service Manual.