Lexicon 300L -, Owner'S Manual

Page: 134 / 162

6-3
Time Code Operation
-24 18 12 6 0 6 +12 ovld dB
L
R
The 300L allows you to use time code (in any of the recognized formats) to trigger
Setup, Effect, and parameter changes.
Up to 50 time code entries can be made on an Event List. Time codes can be
entered via the numeric keypad, they can be "snapped" on the fly while time code
is running, or they can be selected with dedicated sliders.
To access the Event List simply press the LARC CTRL button to enter Control
mode, then use the PAGE button to display page Seven. The upper display will
show:
TIME CODE
DISABLED
The lower display will show:
OFF
Advance the leftmost slider to select VIEW to access the current Event List. The
display will show:
VIEW 00: 00: 00: 00
Advance the slider again to display:
SNAP 00: 00: 00: 00 CLR
Now, the button below the leftmost slider will snap a timecode event each time
it is pressed. The rightmost button will clear the last snapped event from the list.
The Event List number (1-50) is shown on the upper display.
The 300L automatically sorts the Event List based on the time code addresses.
If you add a new event it will be placed on the list at the appropriate place, and
other entries will move in position. If you delete an entry, the remaining entries
will retain their relative positions, but will move up one position.
The Event List
Using time code to
initiate program
changes