32
•
Loosen and remove the screw (E) on the gas spring release lever
(F) using a 3 mm Allen key (see photo 19).Take the gas spring
release lever off the armrest and pull the cable out.
•
Loosen the threaded pin (G) on the trigger lever (H) in the front
gas spring holder (B) using a 3 mm Allen key and pull the cable
out. Remove the cable coating as well as the adjustment screw
(I) and the counter nut (A) using a 8 mm and 10 mm spanner
(see photo 20).
•
Mounting the new cable:
Insert the new gas spring release cable (J) through the release
lever (F) and into the armrest towards the rear and down in
direction of the arrow (see photo 21).
•
Insert the release lever (F) into the armrest:
Attention:
the other
cable, the one of the armrest release mechanism, must run lateral
of the gas spring release lever! It must not run above the gas
spring release lever!
•
Mount the armrest in reverse order. Don’t tighten the counter sunk screw (D) too much, so that
the armrest can be moved easily up and down.
•
Insert the cable again through the cable coating and the adjustment screw (I), then into the gas
spring holder (B). The adjustment screw should have a distance of approx. 3 mm to the counter
nut (A).
•
Pull the cable out of the trigger lever (H) thus far that the trigger lever may till be moved easily.
It should stick out of the gas spring holder (B) by approx. 5 mm. Then fix the cable tension by
tightening the threaded pin (G).
•
Re-mount the small cover using the three oval head screws (see photo 17).
Important check
: when moving the visible part of the cable/cable coating the gas spring release
mechanism should not be activated!
•
If the gas springs don’t release sufficiently, the trigger lever (H) is not being pulled far enough
into the gas spring holder (B) when the gas spring release lever (F) is pressed. The cable tension
is too sluggish. It must be adjusted, see section 8.7..
•
If the gas springs don’t lock sufficiently, the trigger lever (H) sits too deep in the gas spring
holder (B). The cable tension is too tight. It must be adjusted, see section 8.7..
19
F
E
20
H
G
I
A
B
F
J
21
